Regularly inspection 11.6 Performing the regularly inspection
Edition 07/2007 Technical Description DTCO 1381 11 - 19
TD00.1381.00 132 102
Device-specific parameters Depending on the variation of the DTCO 1381, other parameters
that are not legally-stipulated must be updated or acknowledged:
•n-constant
•Drive shaft I/U
•etc.
Other parameter Other parameters can be updated or acknowledged if necessary:
• Installation date
• Date of the next calibration
•etc.
Attention!
Check whether the programmed and saved parameters are
according to the beforehand measured parameters.
To Next Page
Loading...
