SIM5350 AT Command Set
8.9 AT+CGEREP GPRS event reporting
Description
The write command enables or disables sending of unsolicited result codes, “+CGEV” from MT to
TE in the case of certain events occurring in the Packet Domain MT or the network. <mode>
controls the processing of unsolicited result codes specified within this command. <bfr> controls
the effect on buffered codes when <mode> 1 or 2 is entered. If a setting is not supported by the MT,
ERROR or +CME ERROR: is returned.
Read command returns the current <mode> and buffer settings.
Test command returns the modes and buffer settings supported by the MT as compound values.
SIM PIN References
YES 3GPP TS 27.007
Syntax
Test Command Responses
AT+C GE RE P=? +CGEREP: (list of supported <mode>s),(list of supported <bfr>s)
OK
Read Command Responses
AT+CGEREP? +CGEREP: <mode>,<bfr>
OK
Write Command Responses
OK
ERROR
AT+CGEREP=
<mode>[,<bfr>]
+CME ERROR: <err>
Defined values
<mode>
a numeric parameter
0 disables sending of URC, +CGEV. No codes are forwarded to the TE.
1 eables sending of URC, +CGEV. Forward them directly to the TE.
<bfr>
a numeric parameter
0 MT will not buffer any URC. 0 is default value if omitted, and it’s the only supported setting.
+CGEV:
For network attachment, the following unsolicited result codes and the corresponding events are
defined:
▪ +CGEV: NW DETACH
The network has forced a PS detach. This implies that all active contexts have been deactivated.
These are not reported separately.
SIM5350_ATC_V1.02 6/9/2014
121
To Next Page
Loading...
Need help?
General
