SIM5350 AT Command Set
YES V.25ter
Syntax
Write Command Responses
OK ATS5=<value>
ERROR
Defined values
<value>
8 Backspace character (BS, IA5 0/8).
0 to 127 Set command line editing character to this value.
Examples
ATS5=8
OK
3.13 ATS6 Pause Bufore Blind Dialling
Description
Pause before blind dialing.
The command is ignored.
3.14 ATS7 Set Number of Seconds to Wait for Connection Completion
Description
Connection completion timeout.
This parameter specifies the amount of time, in seconds, that the DCE shall allow between either
answering a call (automatically or by the A command) or completion of signaling of call addressing
information to network (dialing), and establishment of a connection with the remote DCE. If no
connection is established during this time, the DCE disconnects from the line and returns a result
code indicating the cause of the disconnection.
SIM PIN References
YES V.25ter
Syntax
Execute Command Responses
ATS7=<value> OK
SIM5350_ATC_V1.02 6/9/2014
20
To Next Page
Loading...
Need help?
General
