SIM5350 AT Command Set
6.2 AT+CFUN Set phone functionality
Description
This command is used to select the level of functionality <fun> in the ME. Level "full
functionality" is where the highest level of power is drawn. "Minimum functionality" is where
minimum power is drawn. Level of functionality between these may also be specified by
manufacturers. When supported by manufacturers, ME resetting with <rst> parameter may be
utilized.
NOTE: AT +C FU N=6 must be used after setting AT+ CF UN =7. If module in offline mode, must
execute AT+ CFUN =6 or restart module to online mode.
SIM PIN References
NO 3GPP TS 27.007
Syntax
Test Command Responses
+CFUN: (list of supported <fun>s), (list of supported <rst>s)
OK
ERROR
AT+CFUN=?
+CME ERROR: <err>
Read Command Responses
+CFUN: <fun>
OK
ERROR
AT+CFUN?
+CME ERROR: <err>
Write Command Responses
OK
ERROR
AT+CFUN=<fun>[,<rst>]
+CME ERROR: <err>
Defined values
<fun>
1 full functionality
4 disable phone both transmit and receive RF circuits (supported only for module solution)
0 minimal functionality, turn off radio and SIM power.
<rst>
0 do not reset the MT before setting it to <fun> power level
1 reset the MT before setting it to <fun> power level
SIM5350_ATC_V1.02 6/9/2014
59
To Next Page
Loading...
Need help?
General
