SIM5350 AT Command Set
Defined values
<flag>
Integer.
0 Received signal level indication disable
1 Received signal level indication enable
<rssi>
Integer.
0-99
Received signal strength indication. This field is the same as <rssi> in +CSQ, which is translated
according to TS 27.007, but not the raw dBm value measured by L1.
<ber>
Integer.
0-255 Bit error rate
<raw_rssi_in_qdbm>
Integer.
Received signal strength raw data in quarter dbm
<RSCP_in_qdbm>
Integer.
RSCP in quarter dbm.
Only avaliabe when camp on UMTS network.
only present when current RAT is UMTS
<EcN0_in_qdbm>
Integer.
EcN0 in quarter dbm.
Only avaliabe when camp on UMTS network.
only present when current RAT is UMTS
Examples
AT+ ECSQ =?
+ECSQ: (0,1)
6.24 AT+ESCRI Send SCRI or Fast Dormancy request to network
Description
This command is used to request the network to enter the Fast Dormancy mode (e.g., Let UE in
CELL_PCH state instead of IDLE state) for power saving purpose
SIM PIN References
YES Vender
Syntax
SIM5350_ATC_V1.02 6/9/2014
79
To Next Page
Loading...
Need help?
General
