SIM5350 AT Command Set
Examples
AT+CAOC=0
+CAOC: "000000"
OK
5.6 AT+CSSN Supplementary service notifications
Description
This command refers to supplementary service related network initiated notifications. The set
command enables/disables the presentation of notification result codes from TA to TE.
When <n>=1 and a supplementary service notification is received after a mobile originated call
setup, intermediate result code +CSSI: <code1>[,<index>] is sent to TE before any other MO call
setup result codes presented in the present document. When several different <code1>s are received
from the network, each of them shall have its own +CSSI result code.
When <m>=1 and a supplementary service notification is received during a mobile terminated call
setup or during a call, or when a forward check supplementary service notification is received,
unsolicited result code +CSSU: <code2>[,<index>[,<number>,<type>[,<subaddr>,<satype>]]] is
sent to TE. In case of MT call setup, result code is sent after every +CLIP result code (refer
command "Calling line identification presentation +CLIP") and when several different <code2>s
are received from the network, each of them shall have its own +CSSU result code.
SIM PIN References
YES 3GPP TS 27.007
Syntax
Test Command Responses
AT+CSSN=? +CSSN: (list of supported <n>s),(list of supported <m>s)
OK
Read Command Responses
AT+CSSN? +CSSN: <n>,<m>
OK
Write Command Responses
OK
ERROR
AT+CSSN=<n>[,<m>]
+CME ERROR: <err>
Defined values
<n>
Parameter sets/shows the +CSSI result code presentation status in the TA:
SIM5350_ATC_V1.02 6/9/2014
53
To Next Page
Loading...
Need help?
General
