SimCom SIM5350

SIM5350 AT Command Set
+CGDCONT: (1-16),"IPV6",,,(0-2),(0-4)
OK
8.2 AT+CGQREQ Quality of service profile (requested)
Description
This command allows the TE to specify a Quality of Service Profile that is used when the MT sends
an Activate PDP Context Request message to the network.. A special form of the set command
(AT+CGQREQ=<cid>) causes the requested profile for context number <cid> to become
undefined.
SIM PIN References
YES 3GPP TS 27.007
Syntax
Test Command Responses
+CGQREQ: <PDP_type>, (list of supported <precedence>s), (list
of supported <delay>s), (list of supported <reliability>s) , (list of
supported <peak>s), (list of supported <mean>s) [<CR><LF>
+CGQREQ: <PDP_type>, (list of supported <precedence>s), (list
of supported <delay>s), (list of supported <reliability>s) , (list of
supported <peak>s), (list of supported <mean>s)
[…]]
OK
AT+CGQREQ=?
ERROR
Read Command Responses
+CGQREQ: [<cid>, <precedence >, <delay>, <reliability>,
<peak>, <mean>[<CR><LF>
+CGQREQ: <cid>, <precedence >, <delay>, <reliability.>, <peak>,
<mean>[…]]]
OK
AT+CGQREQ?
ERROR
Write Command Responses
OK AT+CGQREQ=<cid>
[,<precedence>
[,<delay>[,<reliability>
[,<peak> [,<mean>]]]]]
ERROR
Execution Command Responses
OK AT+CGQREQ
ERROR
SIM5350_ATC_V1.02 6/9/2014
110