SIM5350 AT Command Set
8.6 AT+CGPADDR Show PDP address
Description
The write command returns a list of PDP addresses for the specified context identifiers.
SIM PIN References
YES 3GPP TS 27.007
Syntax
Test Command Responses
AT+CGPADDR=? +CGPADDR: (list of defined <cid>s)
OK
Write Command Responses
[+CGPADDR:<cid>,<PDP_addr>[<CR><LF>
+CGPADDR: <cid>,<PDP_addr>[...]]]
OK
ERROR
AT+CGPADDR=
<cid>[,<cid>[,…]]
+CME ERROR: <err>
Defined values
<cid>
A numeric parameter which specifies a particular PDP context definition (see the +CGDCONT and
+CGDSCONT commands). If no <cid> is specified, an ERROR result code will be returned.
Multiple <cid> field is not supported.
1…16
<PDP_addr>
A string that identifies the MT in the address space applicable to the PDP. The address may be static
or dynamic. For a static address, it will be the one set by the +CGDCONT and +CGDSCONT
commands when the context was defined. For a dynamic address it will be the one assigned during
the last PDP context activation that used the context definition referred to by <cid>.
<PDP_address> is omitted if none is available.
Examples
AT+CGPADDR =?
+CGPADDR: ( 1)
OK
AT+CGPADDR=1
+CGPADDR: 1,"0.0.0.0"
OK
SIM5350_ATC_V1.02 6/9/2014
118
To Next Page
Loading...
