SIM5350 AT Command Set
Execute Command Responses
AT+ESCRI Same as AT+ESCRI=1
Write Command Responses
OK AT+ESCRI=<force_send>
+CMS ERROR:
Defined values
<force_send>
integer
0 RRCE send SCRI depend on NW support FD or not
1 force RRCE send SCRI
6.25 AT+EOPS Enhanced Operator Selection
Description
This command is similar to +COPS, with additional support for specified ARFCN. Set command
forces an attempt to select and register the GSM/UMTS network operator. If the selected operator is
not available, ERROR is returned. Read command returns the current mode, the currently selected
operator. Test command returns operator list present in the network.
SIM PIN References
YES Vender
Syntax
Test Command Responses
+COPS: [list of supported (<stat>,long alphanumeric <oper>,short
alphanumeric<oper>,numeric<oper>,[,<Act>])s][,,(list of
supported<mode>s),(list of supported <format>s)]
AT+EOPS=?
+CME ERROR: <err>
Read Command Responses
+COPS:<mode>[,<format>,<oper>] AT+E OP S?
+CME ERROR: <err>
Write Command Responses
OK AT+EOPS=<mode>[,<forma
t>,<oper>[,<Act>,<arfcn>]]
+CME ERROR: <err>
Defined values
SIM5350_ATC_V1.02 6/9/2014
80
To Next Page
Loading...
Need help?
General
