SIM5350 AT Command Set
string with quotes), (<vp> is in range 0... 255).
<pid>
GSM 03.40 TP-Protocol-Identifier in integer format (default 0).
<dcs>
GSM 03.38 SMS Data Coding Scheme (default 0), or Cell Broadcast Data Coding Scheme in
integer format depending on the command or result code.
Examples
AT+CSMP=17,23,64,244
OK
7.7 AT+CSDH Show text mode parameters
Description
This command is used to control whether detailed header information is shown in text mode result
codes.
SIM PIN References
YES 3GPP TS 27.005
Syntax
Test Command Responses
AT+CSDH=? +CSDH: (list of supported <show>s)
OK
Read Command Responses
AT+C SD H? +CSDH: <show>
OK
Write Command Responses
AT+CSDH=<show> OK
Defined values
<show>
0 – do not show header values defined in commands AT+ CSCA and AT+ CS MP (<sca>,
<tosca>, <fo>, <vp>, <pid> and <dcs>) nor <length>, <toda> or <tooa> in +CMT,
AT+C MG L, AT + CM G R result codes for SMS-DELIVERs and SMS-SUBMITs in text mode;
for SMS-COMMANDs in AT+CMG R result code, do not show <pid>, <mn>, <da>, <toda>,
<length> or <data>
1 – show the values in result codes
SIM5350_ATC_V1.02 6/9/2014
90
To Next Page
Loading...
Need help?
General
