SIM5350 AT Command Set
8 – Up to 128000 (1024 kbit/s)
9 – Up to 256000 (2048 kbit/s)
<mean>
<mean>: a numeric parameter which specifies the mean throughput class0 –
network subscribed value
1 – 100 (~0.22 bit/s)
2 – 200 (~0.44 bit/s)
3 – 500 (~1.11 bit/s)
4 – 1000 (~2.2 bit/s)
5 – 2000 (~4.4 bit/s)
6 – 5000 (~11.1 bit/s)
7 – 10000 (~22 bit/s)
8 – 20000 (~44 bit/s)
9 – 50000 (~111 bit/s)
10 – 100000 (~0.22 kbit/s)
11 – 200000 (~0.44 kbit/s)
12 – 500000 (~1.11 kbit/s)
13 – 1000000 (~2.2 kbit/s)
14 – 2000000 (~4.4 kbit/s)
15 – 5000000 (~11.1 kbit/s)
16 – 10000000 (~22 kbit/s)
17 – 20000000 (~44 kbit/s)
18 – 50000000 (~111 kbit/s)
31 – optimization
Examples
AT+CGQREQ?
+CGQREQ:
OK
AT+CGQREQ=?
+CGQREQ: "IP",(0-3),(0-4),(0-5),(0-9),(0-18,31)
+CGQREQ: "PPP",(0-3),(0-4),(0-5),(0-9),(0-18,31)
+CGQREQ: "IPV6",(0-3),(0-4),(0-5),(0-9),(0-18,31)
OK
8.3 AT+CGQMIN Quality of service profile (minimum acceptable)
Description
This command allows the TE to specify a minimum acceptable profile which is checked by the MT
against the negotiated profile returned in the Activate PDP Context Accept message.A special form
of the set command,AT+CGQMIN=<cid> causes the minimum acceptable profile for context
number <cid> to become undefined.
SIM5350_ATC_V1.02 6/9/2014
112
To Next Page
Loading...
