SIM5350 AT Command Set
(default is empty string);
e.g. "0,1,5,320-478,922”
<dcss>
String type; all different possible combinations of CBM data coding schemes (refer <dcs>) (default
is empty string); e.g. “0-3,5”
Examples
AT+CSCB=?
+CSCB: (0-1)
OK
AT+CSCB=0,”15-17,50,86”,””
OK
7.9 AT+CNMI New message indications to TE
Description
This command is used to select the procedure how receiving of new messages from the network is
indicated to the TE when TE is active, e.g. DTR signal is ON. If TE is inactive (e.g. DTR signal is
OFF). If set <mt>＝2, <mt>＝3 or <ds>＝1, make sure <mode>＝1, otherwise it will return error.
SIM PIN References
YES 3GPP TS 27.005
Syntax
Test Command Responses
AT+CNMI=? +CNMI: (list of supported <mode>s),(list of supported <mt>s),(list
of supported <bm>s),(list of supported <ds>s),(list of supported
<bfr>s)
OK
Read Command Responses
AT+C NM I? +CNMI: <mode>,<mt>,<bm>,<ds>,<bfr>
OK
Write Command Responses
OK
ERROR
AT+CNMI=<mode>[,<mt>[,
<bm>[,<ds> [,<bfr>]]]]
+CMS ERROR: <err>
Defined values
<mode>
SIM5350_ATC_V1.02 6/9/2014
92
To Next Page
Loading...
Need help?
General
