SimCom SIM5350 - AT+CFGRI Indicate RI When Using URC

SIM5350 AT Command Set
This command is used to read values from register of IIC device.
SIM PIN References
NO Vendor
Syntax
Test Command Responses
AT+CRIIC=? OK
Write Command Responses
+CRIIC: <data>
OK
AT+CRIIC=
<addr>,<reg>
ERROR
Defined values
<addr>
Device address. Input format must be hex, such as 0xFF.
<reg>
Register address. Input format must be hex, such as 0xFF.
<data>
Data read. Input format must be hex, such as 0x00—0xFF.
Examples
AT+CRIIC=0x1A, 0x0F
+CRIIC: 0x12
OK
9.11 AT+CFGRI Indicate RI when using URC
Description
This command is used to config whether pulling down the RI pin of UART when URC reported. If
<status> is 1, host may be wake up by RI pin.
SIM PIN References
NO Vendor
Syntax
Test Command Responses
AT+CFGRI=? +CFGRI: (range of supported <status>s), (range of supported
<save>s)
SIM5350_ATC_V1.02 6/9/2014
137