SIM5350 AT Command Set
NOTE: If set <delflag>=1, 2, 3 or 4, <index> is omitted, such as AT+C M G D =,1.
Examples
AT+CMGD=1
OK
8 AT Commands for GPRS
8.1 AT+CGDCONT Define PDP context
Description
The set command specifies PDP context parameter values for a PDP context identified by the
(local) context identification parameter <cid>. The number of PDP contexts that may be in a
defined state at the same time is given by the range returned by the test command. A special form of
the write command (AT+CGDCONT=<cid>) causes the values for context <cid> to become
undefined.
SIM PIN References
YES 3GPP TS 27.007
Syntax
Test Command Responses
+CGDCONT: (range of supported<cid>s),<PDP_type>,,,(list of
supported <d_comp>s),(list of supported <h_comp>s)
OK
AT+CGDCONT=?
ERROR
Read Command Responses
+CGDCONT: [<cid>, <PDP_type>, <APN>,<PDP_addr>,
<d_comp>, <h_comp>[<CR><LF>
+CGDCONT: <cid>, <PDP_type>, <APN>, <PDP_addr>,
<d_comp>, <h_comp>[...]]]
OK
AT+CGDCONT?
ERROR
Write Command Responses
AT+CGDCONT= OK
SIM5350_ATC_V1.02 6/9/2014
108
To Next Page
Loading...
