SimCom SIM5350

SIM5350 AT Command Set
ERROR
+CME ERROR: <err>
Write Command Responses
OK
ERROR
AT+CLIP=<n>
+CME ERROR: <err>
Defined values
<n>
Parameter sets/shows the result code presentation status in the TA:
0 – disable
1 – enable
<m>
0 – CLIP not provisioned
1 – CLIP provisioned
2 – unknown (e.g. no network, etc.)
<number>
String type phone number of calling address in format specified by <type>.
<type>
Type of address octet in integer format;
<alpha>
String type alphanumeric representation of <number> corresponding to the entry found in phone
book.
<CLI validity>
0 – CLI valid
1 – CLI has been withheld by the originator
2 – CLI is not available due to interworking problems or limitations of originating
network
Examples
AT+CLIP=1
OK
RING (with incoming call)
+CLIP: "02152063113",128,,,"gongsi",0
4.10 AT+CLIR Calling line identification restriction
Description
SIM5350_ATC_V1.02 6/9/2014
38