SIM5350 AT Command Set
This command refers to CLIR-service that allows a calling subscriber to enable or disable the
presentation of the CLI to the called party when originating a call.
Write command overrides the CLIR subscription (default is restricted or allowed) when temporary
mode is provisioned as a default adjustment for all following outgoing calls. This adjustment can be
revoked by using the opposite command.. If this command is used by a subscriber without
provision of CLIR in permanent mode the network will act.
Read command gives the default adjustment for all outgoing calls (given in <n>), and also triggers
an interrogation of the provision status of the CLIR service (given in <m>).
Test command returns values supported as a compound value.
SIM PIN References
YES 3GPP TS 27.007
Syntax
Test Command Responses
AT+CLIR =? +CLIR: (list of supported <n>s)
OK
Read Command Responses
+CLIR: <n>,<m>
OK
ERROR
AT+C LI R?
+CME ERROR: <err>
Write Command Responses
OK
ERROR
AT+CLIR =<n>
+CME ERROR: <err>
Defined values
<n>
(parameter sets the adjustment for outgoing calls):
0 presentation indicator is used according to the subscription of the CLIR service
1 CLIR invocation
2 CLIR suppression
<m>
(parameter shows the subscriber CLIR service status in the network):
0 CLIR not provisioned
1 CLIR provisioned in permanent mode
2 unknown (e.g. no network, etc.)
3 CLIR temporary mode presentation restricted
4 CLIR temporary mode presentation allowed
SIM5350_ATC_V1.02 6/9/2014
39
To Next Page
Loading...
