SimCom SIM5350 - 5.2 AT+COPS Operator selection

SIM5350 AT Command Set
3.26 AT+IFC Set local data flow control
Description
This command sets the flow control of the module.
SIM PIN References
NO V.25ter
Syntax
Test Command Responses
AT+IFC=? +IFC: (list of supported<DCE>s), (list of supported<DTE>s)
OK
Read Command Responses
AT+IFC? +IFC: <DCE>,<DTE>
OK
Write Command Responses
OK AT+IFC=<DCE>[,<DTE>]
ERROR
Defined values
<DCE>
0 – none (default)
2 – RTS hardware flow control
<DTE>
0 – none (default)
2 – CTS hardware flow control
Examples
AT+IFC?
+IFC: 0,0
OK
AT+IFC=?
+IFC: (0,2),(0,2)
OK
AT+IFC=2,2
OK
SIM5350_ATC_V1.02 6/9/2014
27