SIM5350 AT Command Set
Cell ID in hexadecimal format.
GSM : Maximum is two byte
WCDMA : Maximum is four byte
<Act>
0 GSM
2 UTRAN
3 GSM EGPRS
4 UTRAN HSDPA
5 UTRAN HSUPA
6 UTRAN HSDPA and HSUPA
Examples
AT+CREG?
+CREG: 0,1
OK
5.2 AT+COPS Operator selection
Description
Write command forces an attempt to select and register the GSM/UMTS network operator. <mode>
is used to select whether the selection is done automatically by the ME or is forced by this
command to operator <oper> (it shall be given in format <format>). If the selected operator is not
available, no other operator shall be selected (except <mode>=4). The selected operator name
format shall apply to further read commands (AT+ CO PS?) also. <mode>=2 forces an attempt to
deregister from the network. The selected mode affects to all further network registration (e.g. after
<mode>=2, ME shall be unregistered until <mode>=0 or 1 is selected).
Read command returns the current mode and the currently selected operator. If no operator is
selected, <format> and <oper> are omitted.
Test command returns a list of quadruplets, each representing an operator present in the network.
Quadruplet consists of an integer indicating the availability of the operator <stat>, long and short
alphanumeric format of the name of the operator, and numeric format representation of the operator.
Any of the formats may be unavailable and should then be an empty field. The list of operators shall
be in order: home network, networks referenced in SIM, and other networks.
It is recommended (although optional) that after the operator list TA returns lists of supported
<mode>s and <format>s. These lists shall be delimited from the operator list by two commas.
When executing AT+COPS=? , any input from serial port will stop this command.
SIM PIN References
NO 3GPP TS 27.007
Syntax
SIM5350_ATC_V1.02 6/9/2014
47
To Next Page
Loading...
Need help?
General
