SIM5350 AT Command Set
10 AT Commands for Phone Book
11 Appendixes
11.1 Verbose code and numeric code
Verbose result code Numeric (V0 set) Description
OK 0 Command executed, no errors, Wake up after reset
CONNECT 1 Link established
RING 2 Ring detected
NO CARRIER 3 Link not established or disconnected
ERROR 4 Invalid command or command line too long
NO DIALTONE 6 No dial tone, dialing impossible, wrong mode
BUSY 7 Remote station busy
NO ANSWER 8 Connection completion timeout
11.2 Response string of AT+CEER
Number Response string
CS internal cause
0 Phone is offline
21 No service available
25 Network release, no reason given
27 Received incoming call
29 Client ended call
34 UIM not present
35 Access attempt already in progress
36 Access failure, unknown source
38 Concur service not supported by network
29 No response received from network
45 GPS call ended for user call
46 SMS call ended for user call
47 Data call ended for emergency call
48 Rejected during redirect or handoff
100 Lower-layer ended call
SIM5350_ATC_V1.02 6/9/2014
142
To Next Page
Loading...
Need help?
General
