SIM5350 AT Command Set
as '5E3' (e.g. AT+CGEQREQ=…,'5E3',…). '0E0' means subscribed value.
<Delivery of erroneous SDUs>
A numeric parameter that indicates whether SDUs detected as erroneous shall be delivered or not.
0 - no
1 - yes
2 - no detect
3 - subscribed value
Other values are reserved.
<Transfer delay>
A numeric parameter (0,1,2,…) that indicates the targeted time between request to transfer an SDU at
one SAP to its delivery at the other SAP, in milliseconds. If the parameter is set to '0' the subscribed value
will be requested.
<Traffic handling priority>
A numeric parameter (1,2,3,…) that specifies the relative importance for handling of all SDUs
belonging to the UMTS bearer compared to the SDUs of other bearers. If the parameter is set to '0' the
subscribed value will be requested.
<PDP_type>
(See +CGDCONT and +CGDSCONT commands).
Examples
AT+CGEQREQ?
+CGEQREQ:
OK
AT+CGEQREQ=?
+CGEQREQ: "IP",(0-4),(0-384),(0-7168),(0-384),(0-7168),(0-2),(0-1520),("0E0","1E
1","1E2","7E3","1E3","1E4","1E5","1E6"),("0E0","5E2","1E2","5E3","4E3","1E3","1E
4","1E5","1E6","6E8"),(0-3),(0,100-4000),(0-3)
+CGEQREQ: "PPP",(0-4),(0-384),(0-7168),(0-384),(0-7168),(0-2),(0-1520),("0E0","1
E1","1E2","7E3","1E3","1E4","1E5","1E6"),("0E0","5E2","1E2","5E3","4E3","1E3","1
E4","1E5","1E6","6E8"),(0-3),(0,100-4000),(0-3)
+CGEQREQ: "IPV6",(0-4),(0-384),(0-7168),(0-384),(0-7168),(0-2),(0-1520),("0E0","
1E1","1E2","7E3","1E3","1E4","1E5","1E6"),("0E0","5E2","1E2","5E3","4E3","1E3","
1E4","1E5","1E6","6E8"),(0-3),(0,100-4000),(0-3)
OK
9 AT Commands for Hardware
This chapter describes the AT commands related hardware, notes that all commands is base on standard
SIM5350 module, SIM5350 series module hardware interface may be different, more details please refer
the module hardware design document, such as SIM5350-PCIE module has no SDIO/SPI/UART/GPIO
interfaces, and corresponding AT command is invalid.
SIM5350_ATC_V1.02 6/9/2014
128
To Next Page
Loading...
Need help?
General
