SimCom SIM5350 User Manual

SIM5350 AT Command Set
0 – disable unsolicited result code
1 – Discard indication and reject new received message unsolicited result codes when TA-TE link is
reserved (e.g. in on-line data mode). Otherwise forward them directly to the TE.
2 – Buffer unsolicited result codes in the TA when TA-TE link is reserved (e.g. in online data mode)
and flush them to the TE after reservation. Otherwise forward them directly to the TE.
3 – Forward unsolicited result codes directly to the TE. TA-TE link specific inband technique used
to embed result codes and data when TA is in on-line data mode.
<mt>
0 – No SMS-DELIVER indications are routed to the TE.
1 – If SMS-DELIVER is stored into ME/TA, indication of the memory location is routed to the TE
using unsolicited result code: +CMTI: <mem>,<index>
2 – SMS-DELIVERs (except class 2 messages and messages in the message waiting indication
group (store message)) are routed directly to the TE using unsolicited result code: +CMT:
[<alpha>],<length><CR><LF><pdu> (PDU mode enabled); or +CMT:
<oa>,[<alpha>],<scts>[,<tooa>,<fo>,<pid>,<dcs>,<sca>,<tosca>,<length>] <CR><LF> <data>
(text mode enabled; about parameters in italics, refer command Show Text Mode Parameters
+CSDH)
3 – Class 3 SMS-DELIVERs are routed directly to TE using unsolicited result codes defined in
<mt>=2. Messages of other data coding schemes result in indication as defined in <mt>=1.
<bm>
0 – No CBM indications are routed to the TE.
2 – New CBMs are routed directly to the TE using unsolicited result code:
+CBM: <length><CR><LF><pdu> (PDU mode enabled); or
+CBM: <sn>,<mid>,<dcs>,<page>,<pages><CR><LF><data> (text mode enabled)
If ME supports data coding groups which define special routing also for messages other than
class 3 (e.g. (U)SIM specific messages), ME may choose not to route messages of such data
coding schemes into TE (indication of a stored CBM may be given as defined in <bm>=1).
3 – Class 3 CBMs are routed directly to TE using unsolicited result codes defined in <bm>=2. If
CBM storage is supported, messages of other classes result in indication as defined in <bm>=1.
<ds>
0 – No SMS-STATUS-REPORTs are routed to the TE.
1 – SMS-STATUS-REPORTs are routed to the TE using unsolicited result code:
+CDS: <length><CR><LF><pdu> (PDU mode enabled); or
+CDS: <fo>,<mr>,[<ra>],[<tora>],<scts>,<dt>,<st> (text mode enabled)
<bfr>
0 – TA buffer of unsolicited result codes defined within this command is flushed to the TE when
<mode>.
1...3 is entered (OK response shall be given before flushing the codes).
1 – TA buffer of unsolicited result codes defined within this command is cleared when <mode> 1...3
is entered.
Examples
SIM5350_ATC_V1.02 6/9/2014
93

SimCom SIM5350 Specifications

General

Brand	SimCom
Model	SIM5350
Category	Control Unit
Language	English