SimCom SIM5350 User Manual

SIM5350 AT Command Set
0 – disable
1 – enable
<m>
Parameter sets/shows the +CSSU result code presentation status in the TA:
0 – disable
1 – enable
<code1>
(it is manufacturer specific, which of these codes are supported):
0 – unconditional call forwarding is active
1 – some of the conditional call forwardings are active
2 – call has been forwarded
3 – call is waiting
4 – this is a CUG call (also <index> present)
5 – outgoing calls are barred
6 – incoming calls are barred
7 – CLIR suppression rejected
8 – call has been deflected
<index>
Refer "Closed user group +CCUG".
<code2>
(it is manufacturer specific, which of these codes are supported):
0 – this is a forwarded call (MT call setup)
1 – this is a CUG call (also <index> present) (MT call setup)
2 – call has been put on hold (during a voice call)
3 – call has been retrieved (during a voice call)
4 – multiparty call entered (during a voice call)
5 – call on hold has been released (this is not a SS notification) (during a voice call)
6 – forward check SS message received (can be received whenever)
7 – call is being connected (alerting) with the remote party in alerting state in explicit call
transfer operation (during a voice call)
8 – call has been connected with the other remote party in explicit call transfer operation
(also number and subaddress parameters may be present) (during a voice call or MT
call setup)
9 – this is a deflected call (MT call setup)
10 – sdditional incoming call forwarded
<number>
String type phone number of format specified by <type>.
<type>
Type of address octet in integer format;
<subaddr>
String type sub address of format specified by <satype>.
<satype>
Type of sub address octet in integer format, default 128.
SIM5350_ATC_V1.02 6/9/2014
54

SimCom SIM5350 Specifications

General

Brand	SimCom
Model	SIM5350
Category	Control Unit
Language	English