A-5
4007ES Panel Programmer Manual (579-1167)
Alarm Cutout Timer Feature, Continued
Programming the
LED
Figure A- 5. Custom Control Equation to Turn ON Pseudo Point
Figure A- 6. Custom Control Equation to Turn OFF Pseudo Point
Step 3: Program the LED to reference the assigned pseudo point.
1. Review the section detailing how to program the LED module, see Chapter 6.
2. Select a YELLOW LED to program. Set the Mode to ON and set the Reference Address to
the pseudo assigned in Step 1, as shown in Figure A-7.
3. Click OK.
To Next Page
Loading...
