Simplex 4007ES - Chapter 7 Editing Truealert Devices Properties; Introduction

7-1
Chapter 7.
Editing TrueAlert Devices Properties
Introduction TrueAlert devices are edited through the Point Editing tab on the IDNAC Power Supply.
To access this tab:
1. Go to the Hardware Configuration window.
2. Double click on the IDNAC Power Supply icon.
3. Click on the Point Editing tab.
In this chapter
TrueAlert ES AO Appliance Point Editing ...... 7-2 TrueAlert ES VO Appliances Point Editing .... 7-3
TrueAlert ES VO-H Appliances Point Editing 7-4 TrueAlert ES VO-L Appliances Point Editing 7-5
TrueAlert ES VO-LH Appliances Point Editing7-6 TrueAlert ES AV Appliance Point Editing ...... 7-7
TrueAlert ES AV-H Appliance Point Editing... 7-9 TrueAlert ES AV-L Appliance Point Editing. 7-11
TrueAlert ES AV-LH Appliance Point Editing7-13 ISO Options ................................................... 7-15
Repeater Options ............................................ 7-15 DCAI Options ................................................ 7-16
TrueAlert STRB Appliances Point Editing.... 7-16 TrueAlert Horn Appliance Point Editing....... 7-17
TrueAlert A/V Appliances Point Editing ....... 7-18