6-19
4007ES Panel Programmer Manual (579-1167)
Editing Standard Component Properties, Continued
48-LED Module In High Level Mode:
1. Select a column and then a point that needs to be edited. LED pairs are yellow and red.
2. Select the Mode from the Mode drop-down list. Under this mode, only three options are
available. If an error is detected, a red “X” is displayed in the HW Ref column. Pass the
mouse over the row to display the tool tip describing the problem.
• OO : On/Off
• TO: Trouble On
3. Create Reference Address for the points by pressing F9.
• Select an address from the table. Scroll through the list and press the space key to
select an address. A “>>” symbol appears indicate that it is selected.
4. Enter a point custom label. This label should make the point easily identifiable.
5. When editing the 8 points of the Display Column 6, LED pairs can be either yellow/red or
yellow/green.
6. Repeat for each point that needs to be edited.
In Low Level Mode:
1. Select a column and then a point that needs to be edited. Point type:
• For the even-numbered points 2 through 40, the default LED point type is LEDRED.
• For the odd-numbered points 1 through 39, the default LED point type is
LEDYELLOW.
2. Select the Mode from the Mode drop-down list.
3. Create Reference Address for the points by pressing F9.
• Select an address from the table. Scroll through the list and press the space key to
select an address. A “>>” symbol appears indicate that it is selected.
4. When editing the 8 points of the Display Column 6:
• For the even-numbered points, the default LED point type is LEDRED. The address of
the point depends on the LED point type selected. The point type can be changed to
LED green.
• For the odd-numbered points, the default LED point type is LEDYELLOW.
To Next Page
Loading...
