If the bearing mode is set to true, the North indicator always
points to true North.
You can switch the North indicator On or Off. On the default.
¾
To change the north indicator line setting:
• Display the Radar screen and main menu. If you can't see the
Range and Bearing button, select Return.
• Select
Range and Bearing.
• The
Show North Indicator button shows the current
setting. Select it to change the setting.
Radar: Heading marker
The heading marker is a blue, dotted line. It extends from your
vessel to the edge of the compass ring, indicating the direction you
are heading.
You can hide the heading marker temporarily. You can't turn it off.
¾
To hide the heading marker temporarily
• Display the Radar screen and main menu. If you can't see the
Range and Bearing button, select Return.
• Select
Range and Bearing.
• Select the
Hide Heading Marker button.
• If you want to hide the heading marker for more than a few
seconds, hold down the
Hide Heading Marker button, then
release the button to re-display it.
Radar: Range rings
Range rings estimate the distance of a target from your vessel.
The spacing interval between the range rings is automatically set.
The scale is shown in the status bar at the top of your
Radar
screen.
You can switch the range rings On or Off. On is the default.
¾
To change the range rings setting:
• Display the Radar screen and main menu. If you can't see the
Range and Bearing button, select Return.
• Select
Range and Bearing.
• The
Range Rings button shows the current setting. Select it
to change the setting.
Radar |115
To Next Page
Loading...
