• If you can't see the
Chart Orientation button, select
Settings then Chart Orientation.
• The
Chart Orientation button shows the current setting.
Select it to change the setting.
3.15 Chart: Vessel offset selection
When Show Vessel is On, you can choose to show your vessel's
position on the
Chart in Look Ahead mode or Center mode. Look
Ahead is the default.
•
Look Ahead. Your vessel is positioned towards the edge of
the
Chart, to give you a good view of what lies ahead. When
your vessel has traveled a certain distance, the
Chart scrolls
automatically to reposition your vessel and maintain a good
view of what lies ahead. (You can change the distance to be
traveled before the
Chart scrolls automatically; see GB40
Setup: Navigation.)
•
Center. Your vessel is shown in central area of the Chart,
traveling towards the edge. When your vessel moves a certain
distance out of the central area, the
Chart scrolls automatically
so that your vessel is shown in the central area again. (You can
change the distance to be traveled before the
Chart scrolls
automatically, see GB40 Setup: Navigation.)
If you change this setting, it's also changed on any other display
units that show the same
Chart view.
¾
To change the vessel offset mode:
• Make the Chart pane active.
• Select
Chart View. (If this button is not in the main menu,
make the
Chart pane active, or select Return / Settings.)
• Select the preset
Chart view you want to change.
• If you can't see the
Vessel Offset button, select Settings.
• The
Vessel Offset button shows the current setting. Select it
to change the setting.
3.16 Chart: Detail selection
You can use this to select from three different levels of detail on
the
Chart:
•
Base shows the least detail.
52 | Chart
To Next Page
Loading...
Need help?
General
