Radar: Active waypoints & routes - show/hide
You can show or hide the active waypoint or active route on your
Radar screen. You can show the name, the range and bearing, and
the TTG for the active waypoint.
If an active route or waypoint is shown on your
Radar screen, you
can switch the details On or Off. Off is the default.
¾
To show or hide the active waypoint or route:
• Display the Radar screen and main menu. If you can't see the
Presentation button, select Return.
• Select
Presentation then Waypoints and Routes.
• The
Show Active Waypoint button or Show Active
Route
button shows the current setting. Select it to change
the setting.
¾
To show or hide the details:
• The Show Active Waypoint button or Show Active
Route button must be switched On if you want to show the
details.
• The
Show Details button shows the current setting. Select it
to change the setting.
8.13 Radar: Range & bearing
This section explains how to:
• find the range and bearing with the cursor.
• find the range and bearing with fixed VRM/EBL.
• show or hide a fixed VRM/EBL.
• find the range and bearing with floating VRM/EBL.
Radar: Measure with the cursor
You can use the cursor to quickly find the precise range and
bearing of a target from your vessel.
You can also use one or both of the VRM/EBL (Variable Range
Markers/Electronic Bearing Lines).
¾
To find the range and bearing of a target with the
cursor:
• Select the target on your Radar screen.
• The range and bearing is shown in the status bar at the top of
the
Radar screen, next to the cursor readout. Select the cursor
116 | Radar
To Next Page
Loading...
Need help?
General
