◦ Rename Panel. Rename the current panel. Use the
keyboard to enter a new name for the panel. Select
OK.
◦ Delete Panel. Delete the current panel. Confirm the
deletion. Select
OK.
9.3 Instruments: Configure gauge
You can show data on a gauge in digital or analog format. Digital is
the default.
If you show the data in analog format, you can customize the
number of marks around the circumference of the gauge, label
steps, and show a maximum of 3 color zones.
¾
To set a gauge as analog:
• Select Configure Gauge from the Instruments control
panel.
• Select the appropriate gauge then select
Gauge Type:
Digital
. This changes the gauge to Analog and also updates
the description of the status bar.
¾
To customize an analog gauge:
• Select Config Analog Gauge.
Each of the buttons featured on the Config Analog Gauge
pane are optional settings.
◦ Scale:
Scale Minimum: set the scale's lowest value.
Scale Maximum: set the scale's highest value.
Scale Label Step: set the value points where numerical
labels will appear.
Marks are scaled automatically to provide the optimum
display for the gauge.
◦ Color Range 1, 2, 3. These buttons create colored arcs
to act as quick-reference zone indicators.
Range Visible: You can set the range, then switch the
range on or off.
Range Minimum: set the range's start point.
Range Maximum: set the range's finish point.
Range Color: Select an appropriate color.
132 | Instruments
To Next Page
Loading...
