3.42 Chart: GoTo next or previous waypoint
¾
To navigate to the previous or next waypoint:
• Select GoTo. (If this button is not in the main menu, make the
Chart pane active, or select Return / Settings.)
• If there's an active route or waypoint already on the
Chart,
select
Previous Waypoint or Next Waypoint.
The GB40 creates a temporary waypoint at your vessel's
current position, then draws a line between the temporary
waypoint and the destination waypoint.
3.43 Chart: Reverse a route
Note: This works only when a route is displayed on the Chart.
¾
To reverse your route:
• Select any one of the route legs.
The selected route is shown in red.
• Select
Reverse Route. The GB40 immediately renumbers all
the waypoints in reverse order and updates the arrows to show
the new direction.
• When you are finished, select
Return.
3.44 Chart: Reset the XTE
Note: This works only when there is an active route or
waypoint.
You can reset the XTE (cross track error) when you're off course
and want to steer to the next waypoint from your current position,
rather than steering back to the original course.
You can also reset the XTE from the
3D Steer screen.
Check that the new course between your current position
and the next waypoint is at a safe depth and contains no
hazards or obstacles.
Chart |73
To Next Page
Loading...
