3.25 Chart: Light sectors on/off
You can switch the light sectors On or Off on your Chart.
Some lights show different colors when they're viewed from
different bearings. The different colors indicate different light
sectors.
Although the color of the light will change depending on your
bearing, the characteristics of the light, such as a three second
flash, will not change.
Light sectors may be only a few degrees wide, or they may cover a
wide arc.
If you change this setting, it's also changed on any other display
units that show the same
Chart view.
¾
To change the light sectors setting:
• Select Chart Presentation. (If this button is not in the
main menu, make the
Chart pane active, or select Return /
Settings
.)
• The Light Sectors button shows the current setting. Select it
to change the setting.
• When you are finished, select
Return.
3.26 Chart: Lat/Long grid overlay on/off
You can switch the Lat/Long grid overlay On or Off on your Chart
screen. Off is the default.
If you change this setting, it's also changed on any other display
units that show the same
Chart view.
Note: This works only when the chart orientation is set to
North Up.
¾
To change the Lat/Long grid setting:
• Select Chart Presentation. (If this button is not in the
main menu, make the
Chart pane active, or select Return /
Settings.)
• Select More Chart Settings.
• The
Lat/Long Grid button shows the current setting. Select
it to change the setting.
• When you are finished, select
Return.
Chart |57
To Next Page
Loading...
Need help?
General
