• Check that the
Chart has the Radar Overlay turned On.
• Select the
Radar pane so that it becomes active. If you can't
see the
Adjust Radar button, select Return.
• Select
Adjust Radar, then select Installation.
• The
Bearing Alignment button shows the current setting.
Select it to change the setting.
• Use the
Up and Down buttons to move the radar image one
degree at a time, until the radar overlay is aligned with the
chart.
• Select
OK.
• When you are finished, select
Return.
Radar |129
To Next Page
Loading...
Need help?
General
