Solid State Logic Matrix2 Delta

Chapter 6 - DAW and CC Conguration
 focussing on


Controller) layers for the control of MIDI devices. Layers and soft key assignments for both DAW and CC layers are stored on

DAW tab in the Matrix Remote:



Matrix Console Layer Selection
          DAW tab,
asdescribed below. However, selecting a layer in the Remote does not select
that layer on Matrix console. The layer which is being controlled from the Matrix
console can then be selected using the
DAW LAYER SELECT buttons, located
in the Matrix centre section, below the digital scribble strip (shown right). The selected button lights to indicate that it is active.
Layer 1 is active when none of the buttons is lit. If you wish to use Layer 1 and another layer is selected, press the lit button to
return to Layer 1.
Matrix Remote Layer Selection
DAW tab’s Layer
radio buttons, located in the middle of the tab towards to top. All other functions
in this tab, with the exception of the
Transport Master
to the selected layer.
Chapter 6 - DAW and CC Conguration
105
Matrix
2
Owner’s Manual