STEP 11: Inserting Signal Processing into the Channel
Most mixing desks have signal processing available in the channel. You will probably be aware by now that Matrix
doesn’t, as the outboard and DAW signal processing with which Matrix is designed to work would make in-
channel processing an unnecessary and costly expense. You can, however, insert your outboard signal processing
into the channel using the Insert Matrix in the Matrix Remote:
³ Press channel 16’s
INSERT button, located between the CHIP and CHOP pots, shown left. Depending
on your setup, the monitoring may now fall silent.
On your computer, run the Matrix Remote and select the
Insert Matrix tab which is the fourth tab from the left. The right
hand-side of the Insert Matrix tab shows you red boxes labelled “
Insert 1”, “Insert 2” etc. These boxes represent your analogue
outboard gear you have connected to the Insert Send and Return connections on the back of Matrix. They are known as Devices.
³ Start by renaming each Device. You can do this by right-clicking and choosing Rename
³ Once you have named your devices use the scroll bar at the bottom, to bring Chan16 into view inside the Insert Matrix
³
click and it will be placed into the insert slot.
The device will then turn red in the
Device list to indicate it is in use
For more information regarding the
Insert Matrix, including how to make chains, see Page 77.
Congratulations on completing the Tutorial. You should now be ready to explore some of the more advanced functions of Matrix.
Chapter 2 - Getting Started
28
Matrix
2
Owner’s Manual
To Next Page
Loading...
Need help?
General
