EasyManuals Logo

Solid State Logic Matrix2 Delta User Manual

Solid State Logic Matrix2 Delta
180 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #55 background imageLoading...
Page #55 background image
Auto So Keys
Auto menu enable the
analogue channel levels to be controlled via MIDI Volume
(CC7) messages received from a DAW or other external
MIDI controller. By creating additional MIDI tracks in
the workstation the analogue channels can be automated
using faders in the DAW layer as MIDI controllers for the
matrix channels and writing volume automation data into

affecting the channel(s) selected using the upper
SEL key.
Selecting
None disables external MIDI control, giving full control of the fader level to the desk faders.
Selecting
Abs disables the physical faders, giving full control of the fader level from received MIDI volume data.
Selecting
Trim enables simultaneous control from both the MIDI data and the physical faders, allowing the received MIDI volume
messages to trim the channel level set by the console faders in Analogue Focus mode. The last three soft keys in the
Auto menu
are functions of the A-FADA mode, where the DAW is controlled by audio tracks within the DAW.
The Automation status of each channel (
None, Abs or Trim) will be stored within each TR snapshot.

AUTO

Selecting
DF1 enables the A-FADA method of automation. DF1 stands for ‘DAW Follow 1’. The analogue channel faders now

Selecting
DF2 enables the A-FADA method of automation. DF2 stands for ‘DAW Follow 2’. The analogue channel faders now

Selecting
Snap restores the last known analogue channel fader positions you had set before one of the DF buttons was pressed
and writes those positions into the DAW.
TR So Keys
The TR soft keys allow Matrix’s Total Recall functions to be controlled from the console (TR is described on page 73):
Enable enables TR for restoring snapshots.
TakeTR takes a TR snapshot.
SetSel sets a TR snapshot to any channels selected using the upper SEL key.
SetAll sets a TR to the whole console.
Cur: displays the TR number which is currently selected in the Total Recall tab of the Matrix Remote.
<< selects the previous TR snapshot
>> selects the next TR snapshot

Chapter 3 - Analogue Signal Flow
47
Matrix
2
Owner’s Manual
MonOpt Mon Meters Auto TR IP Misc Links
None Abs Trim DF1 DF2 Snap

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Solid State Logic Matrix2 Delta and is the answer not in the manual?

Solid State Logic Matrix2 Delta Specifications

General IconGeneral
BrandSolid State Logic
ModelMatrix2 Delta
CategoryMusic Mixer
LanguageEnglish

Related product manuals