Removing Devices
Right-clicking on a device in the Insert Matrix will give you three different options:
Remove selected device - Removes the selected device from the Insert Matrix and places it back into the devices list. Any
Remove ALL devices from selected channel
on.
Remove ALL devices from Matrix - Removes all devices, across all channels of the Insert Matrix and returns them to the
devices list. A pop-up window provides an extra chance to change your mind.
Saving Chains as Presets
If you build a chain that may be of use on another session, you can save this as a preset. For instance you have found a combination
of devices that work well for a singer who may work with again. Click the
Save Chain button which can be found at the bottom
of each channel in the Insert Matrix. A pop-up window will appear asking you to name the chain. The chain will then be shown
in the
Chain list.
Loading Preset Chains from the Chains List
Click the Chains button at the top-right of the devices list to view your saved chains. The Chains list is split into two columns.
The left column displays the names of your saved chains and the right column displays the names and order of devices of the
selected chain. Click on the chain name in the left column to select the desired chain. Looking at the image above, you can see
that two items in the chains list, ‘
4k Vocal 1 - Devs in use’ and ‘4k Vocal 2’.
Chapter 4 - Matrix Remote
80
Matrix
2
Owner’s Manual
To Next Page
Loading...
Need help?
General
