Clr Chan Cuts in Groups menu 5-5
Clr Chan Solos in Groups menu 5-5
Clr Group Cuts in Groups menu 5-5
Clr Group Solos in Groups menu 5-5
Clr Hard Groups in Groups menu 5-5
Copy Project in Project menu 2-5
Copying Mix Data 5-91
Cue and Track Lists Section 4
Cue Information, Editing 4-5
Cue List – Automatic Scrolling 4-3
Cue List, Creating a 4-3
Cues Lists and Project Files 4-9
Cues, Deleting 4-5
Cues, Locating to 4-7
Cues, Moving 4-5
Cues, Naming 4-3
Cues, Renaming 4-5
Cues, Renumbering 4-5
CYCLE button 3-19, 5-3
CYCLE START and END buttons 3-19, 5-3
Cycle End automation mode 5-87
Cycle Fill automation mode 5-87
Cycle Function 3-19
Cycle on the MIX-DESK display 5-3, 3-19
Data Storage 1-3
Data/Delete in FILE/SETUP menu 2-25
Define in FILE/SETUP/Desk Setup menu 8-1
Delete Proj in Project menu 2-17
Desk Config menu 9-5
Desk Here on Serial Machine Control Display 3-7
Desk Layout in Desk Config menu 9-7
Desk Setup menu 5-7, 9-3
Diagnostic in MISC menu 9-15
Disable Desk in MISC/System menu 9-11
Discard on the MIX-DESK display 5-15, 5-29
DiskTrack in MACHINES menu 7-15
DiskTrack Free in Desk Setup menu 9-3
Do Pre in Automation menu 5-39, 5-77
Edit in the MIX-DESK menu 5-25
Edit Mix in the Edit menu 5-25
Editing Fader Data 5-83
Editing Mix Data 5-79
Editing Switch Data 5-79
Enable in the Automation menu 5-27
Entering Names 1-5
Event Jogs 5-3
Index
i-iii
23.8.96
To Next Page
Loading...
