Monitor Cut and Solo
When laying tracks it is often preferable to be able to CUT and SOLO the Monitor
feeds without cutting the Pre-Fader Cue sends to the studio headphones. There is a
link option (LK3) on the upper module card which determines if the Monitor Pre-
Fader Cue sends are cut by the Monitor Cut or not.
In RECORD or REPLAY status, Large fader Cuts do not cut the Pre-Fader Aux sends if
this option has been selected.
In any other status, Pre-Small Fader Aux sends will not be cut by the Small Fader Cut
button if this option has been selected.
Small Faders as Extra Auxiliary Sends
The PRE LF and P(O)ST LF buttons, next to the SMALL
FADER, provide a means of feeding the Channel signal into
the Monitor path in place of the GROUP and TAPE selections.
Note that these two buttons override any GROUP or TAPE
selection.
This is very useful in MIX status for deriving automated
auxiliary sends or clean feeds (see Section 2). These can then
be fed to the Routing Matrix and out to effects devices or cue
lines e.g. Groups 25-48 can be used as clean feeds of a live mix,
the Small Faders being used to send the Channel signal to as
many of these clean feeds as required.
Note that when 4-Channel Pan mode is selected from the computer screen, POST LF is
selected automatically, although the LED does not light.
SL 9000 J Console Operator’s Manual
3-16
22.12.94
24
TAPE
PST
LF
PRE
LF
SF
MIX
GROUP
C
LR
PAN
trim
abs
10
5
0
5
Buttons Selected Source of Small Fader Input
PRE LF Pre-Large Fader
POST LF Post-Large Fader
To Next Page
Loading...
Need help?
General
