The MISC Menu
The MISC menu provides access to a range of options which are used for basic setting
up of the SL 9000 J system. In addition, facilities are provided here for diagnostic tests.
Please note that these diagnostics routines should only be used by qualified personnel.
Calibration
Note that this menu selection is not normally available unless it has been activated by
a qualified SSL Engineer. If it is present, do NOT mess with the Fader Calibration
Menu unless you know what you are doing. Refer to the SL 9000 J Series Service
Manual for further details. If in doubt, contact a qualified SSL Engineer.
Tools
Among other things, the Tools menu provides facilities for the installation of new
software. Floppy disks are also formatted via this menu.
The Install pop-up is used for the installation of new or updated software. Before
proceeding, please read carefully the installation instructions provided with each
software update.
Laser Print prints a text file to a connected postscript printer.
Format (see opposite) enables new floppy disks, loaded in the computer’s floppy
drive, or Magneto-Optical discs to be formatted. These disks may then be used for file
transfer, copies or backups as described earlier in this manual. Stab on the Disk box to
toggle between Mag Opt or Floppy. Select the Volume box to enter a disk name. END
or OK out of the QWERTY pop-up, then hit DO IT to start the formatting process.
Calculator provides a numeric calculator! Freelance mixers can use this to work out
their expenses between takes.
Setup Options
9-9
16.8.96
To Next Page
Loading...
Need help?
General
