Sonoscape SSI-6000

SSI-6000/SSI-5800/SSI-5500/SSI-5500BW
Digital Color Doppler Ultrasound System
Chapter 3
Starting the System
Contents
3.1 Probe Connection . . . . . . . . . . . . . . . . . . . . . . . . . . 3-1
3.2 Boot Up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-2
3.3 Patient Information . . . . . . . . . . . . . . . . . . . . . . . . . 3-2
3.4 Start Ultrasound Diagnosis . . . . . . . . . . . . . . . . . . . . . 3-4
3.4.1 Customized application mode (Create New Exam Mode) . 3-4
3.4.2 Annotation and Bodymark . . . . . . . . . . . . . . . . . 3-4
3.1 Probe Connection
Attention!
• Prior to connecting or disconnecting a probe freeze the
image or enter the preparation mode (EXAM screen).
• It is unnecessary to switch the unit off.
• If a probe is disconnected while it is active scanning, a soft-
ware error may occur. In this case switch the ultrasound
system OFF and later ON (perform a restart).
Instructions:
• Plug the probe into the probe socket.
• Switch the lock clockwise to vertical direc-
tion to lock the probe.
• If the cable is too long, you may hang it on
the cable hook at the right side panel.
P/N: 4701-0061-01B
3-1