114
Interface Processor D Series
Interface Processor D Series
Specifications
Inputs/outputs
Digital signal input:
DIGITAL IN (HDCAM) connector (BNC type)
(1), HD serial digital signal conforming to
SMPTE291M/292M/299M,BTA-004B/005B/00
6B)
Input impedance:
75 Ω, unbalanced
Input return loss:
15 dB or more (5 MHz to 741.8 MHz)
10 dB or more (741.8 MHz to 1.484 GHz)
Transmission loss:
20 dB or less (at 741.8 MHz)
Cable length:
HD-SDI: 100 m max. (Using 5CFB coaxial
cable or equivalent cable)
SDTI: 200 m max. (Using Belden 8281,
Fujikura 5C2V or equivalent cable)
Active through output:
75 Ω, unbalanced
SYNC signal input:
REF IN connector (BNC type) (1)
1125 or 525 SYNC signal
Input impedance:
75 Ω, unbalanced
Loop-through output:
With 75 Ω termination switch
Digital signal outputs:
SDTI (HDCAM) OUT connectors (BNC type)
(3)
HDCAM over SDTI signal conforming to
SMPTE305M
Output signal amplitude:
800 m Vp-p +/-10% (at 75 Ω)
Output impedance:
75 Ω, unbalanced
Output return loss:
15 dB or more (5 MHz to 270 MHz)
Digital input/output system delay
REF lock:
2 frames (to reference)
Minimum delay:
1.2 frames (to input)
ISR output information
Status messages:
8 items
Set-up messages:
3 items
General
Power requirements:
+5 V DC: 1.8 A, -5 V DC: 1.2 A
(Supplied from the PFV-HD300A/HD50A
Interface Unit)
Power consumption:
Approx.15 W
Operating temperature:
5 to 40 °C (41 to 104 °F)
Storage temperature:
-20 to 55 °C (-4 to 131 °F)
Operating humidity:
10 to 90% (without condensation)
Dimensions
Board (H x W):
194 x 310 mm
(7 3/4 x 12 1/4 inches)
Connector panel (H x D x W):
218 x 98 x 25 mm
(8 5/8 x 3 7/8 x 1 inches)
Mass
Board:
Approx. 700 g (1 lb 8.7 oz)
Connector panel:
Approx. 300 g (10.6 oz)
Service Part: Extension Board
SDTI
(270 Mb/s)
SDTI
(270 Mb/s)
HD SDI
(1.5 Gb/s)
S/P P/SENC
HD SDI
(1.5 Gb/s)
1
2
3
REF. SYNC
525 (B.B)
or
REF. SYNC
1125 (TRI. SYNC)
*SGC_0099-0116 02.3.16 5:05 PM Page 114
To Next Page
Loading...
