ST STM32F0 Series User Manual

PM0215 The STM32 Cortex-M0 instruction set
Doc ID 022979 Rev 1 65/91
3.7.7 MSR
Move the contents of a general-purpose register into the specified special register.
Syntax
MSR spec_reg, Rn
where:
● ‘Rn’ is the general-purpose source register.
● ‘spec_reg’ is the special-purpose destination register: APSR, IPSR, EPSR, IEPSR,
IAPSR, EAPSR, PSR, MSP, PSP, PRIMASK, or CONTROL.
Operation
MSR updates one of the special registers with the value from the register specified by Rn.
See MRS on page 64.
Restrictions
Rn must not be SP and must not be PC.
Condition flags
This instruction updates the flags explicitly based on the value in Rn.
Examples
MSR CONTROL, R1 ; Read R1 value and write it to the CONTROL register

ST STM32F0 Series Specifications

General

Series	STM32F0
Core	ARM Cortex-M0
Operating Frequency	Up to 48 MHz
Flash Memory	16 KB to 256 KB
SRAM	4 KB to 32 KB
ADC Resolution	12-bit
ADC Channels	Up to 16
Operating Voltage	2.0 V to 3.6 V
DAC Resolution	12-bit (some series)
Communication Interfaces	I2C, SPI, USART, USB, CAN
Operating Temperature	-40°C to 85°C
Package Options	LQFP, TSSOP, UFQFPN, WLCSP

Summary

Introduction to STM32F0xxx Programming

About this document

1.1 Typographical conventions

Defines typographical conventions used in the document.

1.2 List of abbreviations for registers

Lists abbreviations used for register descriptions.

1.3 About the STM32 Cortex-M0 processor and core peripherals

Overview of the Cortex-M0 processor and its core peripherals.

The STM32 Cortex-M0 processor

2.1 Programmers model

Describes the Cortex-M0 programmer's model, modes, and stacks.

2.2 Memory model

Details the processor memory map and memory access behavior.

2.3 Exception model

Explains the exception model, states, types, and priorities.

2.4 Fault handling

Covers fault handling mechanisms, including lockup states.

2.5 Power management

Describes sleep and deep sleep modes for power saving.

The STM32 Cortex-M0 instruction set

3.1 Instruction set summary

Summarizes the Thumb instruction set supported by the Cortex-M0.

3.4 Memory access instructions

Covers instructions for loading and storing data from/to memory.

3.5 General data processing instructions

Describes instructions for arithmetic, logical, and data manipulation operations.

3.6 Branch and control instructions

Details instructions for program flow control and branching.

Core peripherals

4.1 About the STM32 Cortex-M0 core peripherals

Introduces the core peripherals and their address map.

4.2 Nested vectored interrupt controller (NVIC)

Details the NVIC's support for interrupts and its registers.

4.3 System control block (SCB)

Describes the SCB for system implementation information and control.

4.4 SysTick timer (STK)

Explains the SysTick timer's functionality and registers.

Revision history