4-1
Operating Instructions Operator Manual 056404-443
4.1 Warnings and Cautions
Before using the table, either in regard to operating it or performing maintenance, in addition to the above warnings
and cautions, ensure familiarity with all safety precautions and pinch point locations presented in S
ECTION 1,
S
AFETY PRECAUTIONS AND PINCH POINTS.
4.2 Uncrating, Installing and Performing Maintenance
Check the overall condition of the table and all applicable accessories/options upon receipt to ensure
nothing was damaged during shipment. If damage appears to have occurred, contact the shipping
company and STERIS.
STERIS recommends that only STERIS-trained or STERIS-supervised personnel attempt to uncrate/crate, install
and perform maintenance on the surgical table. Uncrating, crating, installation or maintenance by others may
result in personal injury or damage to the product.
WARNING – PERSONAL INJURY HAZARD AND POSSIBLE REGULATORY VIOLATION:
Any alteration of the surgical table not authorized or performed by STERIS which could affect its
operation will void the warranty, could adversely affect operator safety and could violate national,
state or local regulations.
WARNING – PERSONAL INJURY HAZARD:
• Keep hands and feet clear of the unloading platform and the table base when unloading the
table. Serious personal injury could result.
• If the integrity of the external protective ground installation or arrangement is in doubt, operate
the table from its internal power source.
WARNING – EXPLOSION HAZARD: Table must not be used in the presence of flammable
anesthetics.
WARNING – TRIPPING HAZARD: Route the power cord to the receptacle to minimize being tripped
over by personnel in the area.
WARNING – PERSONAL INJURY AND/OR EQUIPMENT DAMAGE HAZARD: Table is factory set to
operate at a certain voltage. Use of any other power supply could result in serious personal injury
or table damage.
CAUTION – POSSIBLE EQUIPMENT DAMAGE: When moving the table to or from point of use, roll it
carefully at moderate speed and only over smooth floors. Maximum floor clearance is 1/4" (6.4 mm).
Avoid door and elevator jambs, and obstructions greater than
1/4" (6.4 mm). If necessary, lift table over obstructions, onto trucks, etc. Lift table evenly and only by
the table base. DO NOT transport articles (including accessories) on top of the table, and DO NOT use a
forklift to move the uncrated table.
WARNING – PERSONAL INJURY HAZARD AND POSSIBLE REGULATORY VIOLATION:
Any alteration of the surgical table not authorized or performed by STERIS which could affect its
operation will void the warranty, could adversely affect operator safety and could violate national,
state or local regulations.
BEFORE USING THE TABLE
4
To Next Page
Loading...
