Steris 4095 - Routine Maintenance; 6.1 Read Before Performing Routine Maintenance

6-1
Routine Maintenance Operator Manual 056404-443
6.1 Read Before Performing Routine Maintenance
The routine maintenance procedures described in this section of the manual should be performed regularly at the
indicated intervals. Table usage may require more frequent maintenance than indicated. See S
ECTION 6.7 for
R
EPLACEMENT PARTS. Any maintenance procedures not included in this section should be performed only by
STERIS-trained service personnel fully acquainted with the STERIS 4095 General Surgical Table.
NOTE: Anytime table covers have been removed, the table must be resealed per S
ECTION 6.11, SEALING TABLE
COVERS.
The following preventive maintenance advisories must be observed:
1. Under no circumstances should this equipment be serviced without the Maintenance Manual. This (use of
Maintenance Manual) also meets requirements for essential performance and compliance with
electromagnetic compatibility.
2. The Maintenance Manual can be purchased by contacting STERIS Customer Service.
3. A detailed Preventive Maintenance schedule and replacement parts list can be found in the Maintenance
Manual.
4. Preventive Maintenance is essential in keeping this equipment in optimal working condition. STERIS
recommends establishing an annual maintenance agreement with STERIS service.
5. Customer should maintain a record of all maintenance procedures performed on the table.
6. If a problem occurs, refer to S
ECTION 7, TROUBLESHOOTING.
7. Preventive Maintenance and regular service must be performed according to the Maintenance Manual to
comply with the requirements for essential performance and compliance with electromagnetic compatibility.
8. The Maintenance Manual describes the steps necessary for checking and replenishing the hydraulic oil.
NOTE: Never permit unqualified persons to service the table and Preventive Maintenance is not covered under
warranty.
WARNING – PERSONAL INJURY AND/OR EQUIPMENT DAMAGE HAZARD:
• Repairs and adjustments to this equipment must be made only by STERIS or STERIS-trained
service personnel. Maintenance performed by unqualified personnel or installation of
unauthorized parts could cause personal injury, result in improper equipment performance,
invalidate the warranty, or result in costly damage. Contact STERIS regarding service options.
• Regularly scheduled preventive maintenance is required for safe and reliable operation of this
equipment. Contact STERIS to schedule preventive maintenance.
• Do not service or perform maintenance on equipment while in use.
ROUTINE MAINTENANCE
6