Steris 4095 - 5.3 Universal Hand Control

5-4
056404-443 Operator Manual Operating Instructions
8. Engage floor locks by pressing hand control LOCK button (Refer to Section 5.3, Universal Hand Control, if
needed).
Before placing patient on table, ensure patient does not exceed maximum patient weight of:
• 1100 lbs. (499 kg) Load, Normal and Reverse Patient Position; raise or lower only (no tabletop
articulation or slide).
• 1000 lbs. (454 kg) Load, Normal and Reverse Patient Position; raise or lower; includes all tabletop
articulation except tabletop slide.
• 600 lbs. (272 kg) Load, Normal Patient Position; raise or lower; includes all tabletop articulation and full
tabletop slide, (also includes Reverse patient slide toward patient feet but not patient slide toward patient
head).
• 575 lbs. (260 kg) Load, Normal and Reverse Patient; raise or lower; includes all tabletop articulation and
full tabletop slide, including reverse patient slide toward patient feet and toward patient head.
After verifying patient weight does not exceed table weight capacity, transfer or position patient and ensure
patient is properly restrained (refer to Section 1.4.3, Patient Safety Straps).
NOTE: A patient grounding post/potential equalization terminal (male connector, DIN 42801) is provided. The
mating female connector for patient grounding is not furnished by STERIS.
5.3 Universal Hand Control
5.3.1 Introduction
NOTE: Failure to comply with the safety information contained within can result in injuries, damage to the
equipment or damage to other property.
The Universal Hand Control provides a simple user interface to manipulate all Surgical Table articulations. Uses
other than those described are not recommended and may not be safe.
The Universal Hand Control is to be operated only by users who have been successfully trained on operation of
the applicable Surgical Table in conjunction with the Universal Hand Control. Please contact STERIS for appropriate
guidance in-service and training.