STEYR 4 CYLINDER User Manual

01 ENGINE
Page ENGINE - 70 Z001019/0_6_July 2008
SERVICE MANUAL MARINE ENGINES
01.06.02 Replace support ring rear
Preparation: Replace engine housing,
01.06.01
1 Loosen 7 hexagon screws.
Remove support ring.
2 Clean and degrease all sealing surfaces.
3 Wet sealing area of support ring with surface sealing
agent LOCTITE 509.
4 Mount new support ring
ATTENTION: Replace radial shaft sealing ring.
(VR00107/0)
5 Tighten flange screws of rear ring carrier with a
torque of 28 Nm +/-3.
NOTE: Secure flange screws of rear ring
carrier with thread protection
LOCTITE 243.
06.02 ill.1
ToC

STEYR 4 CYLINDER Specifications

General

Brand	STEYR
Model	4 CYLINDER
Category	Engine
Language	English