GENERAL
Page GENERAL-24 Z001019/0_8_Octobre 2011
SERVICE MANUAL MARINE ENGINES
ToC
ENGINE check - for leakage
LUBRICATION - oil level
change - oil filter
- motor oil
ENGINE check - for leakage
COOLING - fluid level
SYSTEM - hoses, hose clamps
- antifreeze temperature condition
change - antifreeze*) every 24 month
RAW WATER check - hoses, hose clamps
SYSTEM - zinc anodes
- raw water pump V-belt
- impeller
change - raw water pump V-belt*) if required
- impeller*) if required
- zinc anodes*) if corroded > 50%
preserve - raw water circuit*) after season
RAW WATER check - raw water passages*) clean out desposits
COOLER
(OIL-FUEL- in pipelines
AUX.LUBRICANT)
for 246 / 256 change - zinc anodes*) required if more
and 266 only than 50% material
corroded
AIR check - contamination
FILTER change - air filter element
preserve after season
FUEL check - for leakage
SYSTEM - hoses
drain - addtiional fuel filter
change - fuel filter
check - additional fuel filter
preserve - fuel system*) after season
BATTERY check - acid level
- densitiy
ELECTRONICS check - connections*) after season
ELECTRICAL check - connections tighten loose con-
EQUIPMENT - insulation nections. Renew
cables, if required.
INVERSION check - switch*) every 50 hours
SWITCH (Solas only) or every 6 months
DRIVING re-center - driving unit*) see manufacturer's
SYSTEM specifications
V-BELT check - generator & impeller pump adjust tension
- power-steering adjust tension
for all 6 cyl. change - generator*) if required
models - power-steering*) if required
POLY - V - check - belt, pulleys and tighteners
BELT for wear
change - Poly -V-belt every 1050 hours or
for all 4 cyl. every 48 months
models
after first
50 hours
or 6
months
*) notesdaily
every
150 h.
or 12
months
every
300 h.
or 24
months
C2 Service- and Maintenance Schedule
To Next Page
Loading...
Need help?
General
