Page ENGINE - 6 Z001019/0_6_July 2008
01 ENGINE
SERVICE MANUAL MARINE ENGINES
01.00.02 Exchange camshaft housing
cover sealing
1 Release hexagon nuts.
2 Remove camshaft housing cover.
3 For engines with plane sealing surface.
Release camshaft housing cover sealing by means
of screwdriver and remove.
4 For engines with bossed sealing surface.
Remove seal with a scraper and dispose.
5 Clean sealing surface of camshaft housing cover and
camshaft housing.
6 For engines with plane sealing surface.
Position new seal on camshaft housing cover and
press it into the groove, beginning at the half-moon
(ill.2).
7 For engines with bossed sealing surface.
Apply LOCTITE 5900 to sealing surface of camshaft
housing cover; position the new sealing on and force
against the cover.
8 Put camshaft housing cover onto camshaft housing.
Tighten with hexagon nuts SW 10.
00.02 ill.1
00.02 ill.2
ToC
To Next Page
Loading...
Need help?
General
