Z001019/0_8_Octobre 2011 Page GENERAL-37
GENERAL
SERVICE MANUAL MARINE ENGINES
ToC
E 3 Nomenclature
Term Description Example
disassemble Removal of an assembly of a main assembly or of a component
remove of an assembly without other assemblies having been removed
unscrew before
deflange
dismantle
assemble
put on, place Putting on of an assembly on a main assembly or a component
screw on of an assembly without further assemblies being put on
flange for functional performance
mount
disconnect Separating of connections of lines, pipes and hoses, which are
separable
connect Putting together separable connections of lines, pipes and
hoses
pull off Removal of a component with press fit from another
press on Placement of a component with press fit to another
unscrew Opening of turnable locks
tighten Closing of turnable locks
disassemble Removal of an assembly from a main assembly or a component
from an assembly, if other assemblies have been removed
before
assemble Putting on an assembly to a main assembly or a component of
an assembly, if further assemblies are put on for functional
achievement
loosen Partial unlocking of fixing elements of a component or of an
assembly
remove Taking off a fixing element of a component or an assembly
secure Putting on a fixing element of a component or an assembly
and tightening
disassemble Taking apart assemblies into individual components
assemble Putting together components to an assembly
adjust Elimination of a deviation by means of provided equipment or Valve clearance,
start of feeding
readjust Devices or tools operation
refill Adding and replenishing of operating agents
renew Replacing an auxiliary material by a new one Corrosion protection
agent, sealing
material, paint
gauge Reading in actual positions in programming memory
replace Exchanging of a device, a main assembly, an assembly or a
component by the same, new or repaired ones
measure Steps taken to determine the actual status by evaluating of
physical entities
check Steps taken to compare the actual status with a determined Valve lift, piston
diameter, valve
clearance, close
fit, V-belt tension
clean Removal of foreign and auxiliary material
maintain Steps taken to keep the respective determined planned status
To Next Page
Loading...
Need help?
General
