Z001019/0_6_July 2008 Page ENGINE - 31
01 ENGINE
SERVICE MANUAL MARINE ENGINES
01.04 ill.1
01.01.04 Replace pressure regulating valve
for oil cooling jet
Preparation: Disassemble engine casing 01.06.01
Remove pressure regulating valve with open-end
wrench (WS13).
ATTENTION:Screw in pressure regulating valve until
front collar is seated in bore.
Screw in pressure regulating valve
sturdily.
NOTE: Secure thread with structural adhesive
LOCTITE 262.
ATTENTION:Only tested valves with an opening
pressure of 1.6 bar (+/- 0,15 bar) to be
used.
ToC
To Next Page
Loading...
Need help?
General
